EZ Curb Light is an LED Rope lighting system that lets you easily install 50 Feet of LED lighting along the back of any curb. Set yourself and your work apart. Easily add lighting accents to old or new curb creating a stunning look after the sun has gone down. Your customers will be excited by the look it will create in their yard.
LED rope lighting is efficient and long lasting. The 50 feet of rope light will provide 4000 lumens of light while consuming 40 watts of energy. It is rated 50,000+ hours of life. Our rope light is supplied with a rectifier eliminating the undesirable 60 hertz shimmer that exists with cheaper systems., Cheaper LED systems hook an AC power supply directly to the LED's, But an LED only creates light when electricity flows through it in one direction. When you hook an LED directly to an AC power supply the led turns on and off 60 times a second.
Place Rope Light tracks on cured concrete by drilling 1/4 inch mounting holes in the curb. Tracks are pre-drilled - 5 holes in 4 feet. Drill your holes approximately 1 inch deep. Mount the tracks with a hammer and punch using the provided anchors. Push the rope light into the tracks. Connect two wires to the transformer and you are finished.
Control your lighting the way you want after it is installed. The transformer has the following settings: on, off, photocell activated, 4 hour (transformer is turned on with the photocell and then turns off 4 hours later), 6 hour, and 8 hour.
12 volt Low voltage power is safe to use in your yard. The transformer also has a circuit breaker in case an unexpected short occurs
Did you find this useful? Share it.